DIY Solid Surface CountertopsUpdated: Feb. 20, 2023
Install your own solid-surface countertops
You might also like: TBD
Buy the materials
There are sources that will sell solid-surface materials and tools to DIYers. But only if you’re talking about the acrylic material (like Wilsonart, Avonite and Meganite), rather than “engineered stone” (quartz/resin) products like Cambria and Silestone. Engineered stone materials are only available through authorized dealers and are custom made for each job. DIYers can buy solid-surface materials at wholesale prices from solidsurface.com. It sells surplus and discontinued sheets from several major manufacturers.
Full-sheet sizes vary but are usually 30 in. x 144 in. x 1/2 in. (partial sheets are half that size). The square-foot prices vary by pattern and manufacturer, ranging from $10 to $20 per sq. ft. plus shipping ($150 to $300, depending on your location). The total is about one-third of what you’d pay an authorized dealer if it would even sell to you. Solidsurface.com also carries the special adhesives you’ll need for the joinery. And you’ll have to spend about $250 for special tools and materials.
Rip the sheets to size
It’s possible to do the installation yourself if you’ve built a cabinet or two or are an intermediate woodworker. Solid-surface materials can be cut and routed just like wood. Use sharp, carbide-tipped bits and blades so they cut cleanly through the material instead of heating it up and melting it.
The supplier provides great instructions on its Web site, but here’s the routine in a nutshell. Simply rip the sheets with a table saw or circular saw and straightedge to get the 4-in. backsplash and the 1-in. front lip. Then apply the adhesive to the front lip and clamp the pieces together for 30 minutes. Use the special router bit (with a nylon bearing) to rout a decorative edge. Then lay down 3/4-in. plywood over your existing cabinets and install the new countertop. Glue the backsplash and seams and sand them with the special discs.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Circular saw
- Orbital sander
- Table saw
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- 3/4-in. plywood