Saturday Morning Workshop: Contemporary Key Hanger

Stop misplacing your keys! Build this simple, eye-catching key station to keep them in plain sight.


An hour or less






Build this clever key hanger in an hour with two strips of contrasting wood. Each set of keys has its own small fob which nests in between the spacers. Opposing bevels in the spacers and fobs keep your keys from falling on the floor. You don’t need much material, and it’s going to hang on your wall, so splurge on some attractive wood and get building!

Tools Required

  • Drill/driver
  • Miter saw
  • Vise

Materials Required

  • #212 screw eyes
  • 1-in. screws
  • 1/4-in. plywood
  • 1/4x2x12” maple
  • 1/4x2x12” walnut
  • 1x4 pine
  • 3/4-in. screws
  • Wood glue

Cutting List

Contemporary Key Hanger

Project Plans

Contemporary Key Hanger

Project step-by-step (6)

Step 1

Angle the miter saw for a compound bevel

Contemporary Key Hanger

Rotate the miter saw’s base to 15-degrees. Tilt the blade to 15-degrees in the same direction as the base. For example, I rotated the base handle to the right and tilted the blade to the right.

Step 2

Create a zero-clearance miter saw fence

Contemporary Key Hanger

Fasten a 1×4 board to a piece of 1/4-in. plywood with glue and 1-in. screws. Attach the assembly to the miter saw fence with 3/4-in. screws. Cut a kerf in the fence. This creates a tool that allows perfect alignment and will keep your parts from being pulled into the blade and destroyed.

Step 3

Mark and cut the compound bevels

Contemporary Key Hanger

Make a mark 1/2-in. from one end of the spacer board. Align the mark with the fence’s kerf and make the compound bevel cut. Measure 1/2-in. from the short edge of the board. Align the mark with the kerf and mark a line on the fence where the offcut piece ends. Make the second cut, flip the board edge-over-edge and line up the end with the mark on the fence. Repeat the process until the all the spacers (B) and key fobs (C) are cut.

Step 4

Glue the spacers

Contemporary Key Hanger

Lay out the spacers and fobs so that the grain lines up like one continuous piece. Spread glue onto the backs of the spacers (B). Making sure that the compound bevels are facing the correct way to hold the fobs in place, clamp the spacers (B) in place with painter’s tape, using the fobs (C) as for perfect alignment.

Step 5

Cut to a finished length

Contemporary Key Hanger

Return your miter saw to 90-degrees. Mark a line 1/2-in. from the long corner of the last key fob (C) and cut the assembly to length.

Step 6

Install the eye screws

Contemporary Key Hanger

In the narrow ends of the fobs, punch starting points using an awl, and then drill pilot holes for eye screws. Sand and finish the holder assembly and fobs, then install in the eye screws.

Contemporary Key Hanger

Looking for a more rustic key hanger to build? Try this one.