How to Make a Cottage Shelf with BranchesUpdated: Jun. 14, 2019
Create this distinctive display tree branch shelf in minutes
You might also like: TBD
- An hour or less
- Less than $20
Tree branch shelf: Cut the pieces and fasten them to the wall
Photo 1: Cut the branches
Build a simple jig to hold the branch steady. Cut the ends flush with the end of the jig.
Photo 2: Drill shelf holes
Trace around the branches where they touch the shelf bottom, then drill the holes and screw the shelf to the branches.
Bring a bit of nature indoors with this simple branch-supported tree branch shelf. You’ll have to find two forked branches about 1 in. in diameter, with one relatively straight side that will sit as flush to the wall as possible. We trimmed our branches from a crab apple, but you can use any smooth-barked tree. Our tree branch shelf is 12-in. melamine closet shelving with the ends painted white. Yours can be any wood you like, but keep the width to 12 in. or less.
To make square cuts on the branch ends, create a jig with scrap wood and a 2×4. Clamp the jig to your workbench. Then clamp each branch to the 2×4 and use the bottom edge of the jig to guide your cuts (Photo 1). Cut the branches above the crotch where the ends will be wide enough to support the shelf—one near the wall, the other close to the edge.
Clamp the tree branch shelf to the jig and trace around the branch. Drill pilot holes near the bottom of the marks at the front edge of the shelf so the screw tips won’t poke through the branch (Photo 2). Bore countersink holes for the screw heads at the top of the shelf. Then hold the branches tight to the shelf while screwing them in. Hold the shelf level while you drill two holes through each branch into the drywall to mark the wall for drywall anchors. Screw your new tree branch shelf to the wall and fill it with your treasures.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Cordless drill
- Drill bit set
- Stud finder
- Tape measure
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- 1x12 shelf
- 24 x 48 x 3/4-in. plywood
- Drywall anchors