How to Test a Spark Plug to See If It’s Working

Every small gasoline engine has a spark plug, and this key component requires periodic inspection and testing. Learn how to do it here.

Next Project
Time

An hour or less

Complexity

Beginner

Cost

Free

Introduction

Spark plugs are found in all gasoline engines. Their job is to ignite the air/fuel mixture inside the engine with just the right timing. Age, use and poor fuel quality can all contribute to a spark plug that's dirty and doesn't spark properly.

Failure to start or hard starting are two symptoms of a bad spark plug, as is rough running, higher fuel consumption and less power than usual. Learning to test a spark plug is a basic part of troubleshooting any small engine. The job takes just a few minutes and costs little or nothing.

How spark plugs work

  • Spark plugs are always located at the top of the cylinder head of small engines. Cylinders like these have cooling fins on the outside and are one of the largest parts of any small gasoline-powered engine.
  • All spark plugs thread into a hole in the cylinder head.
  • A thick wire and fitting pushed over the end of the spark plug delivers the electric power needed to make the hidden tip of the spark plug spark.
  • The ignition system of the engine sends a pulse of very-high-voltage current through this wire and into the spark plug — typically 20,000 to 30,000 volts for a small engine.
  • The tip of the plug sits just inside the combustion chamber of the engine in the cylinder head and includes a small gap.
  • When high-voltage electricity encounters this gap, it jumps the air space on its way to complete the circuit by flowing into the engine block. This jumping creates a visible spark that ignites the air/fuel mixture inside the engine so it can run.
  • All problems with spark plugs boil down to a handful of deficiencies that prevent or impair electricity from jumping the all-important spark plug gap.

Tools Required

  • Spark plug tester (optional)
  • Spark plug wrench

Project step-by-step (4)

Step 1

Remove the spark plug wire

  • Remove the shroud that covers the spark plug on a chainsaw or outboard motor. Small engines on lawn mowers and lawn tractors usually do not have spark plug shrouds.
  • Pull the ignition wire off the end of the spark plug. Don’t just yank on the body of the wire itself, though, because this can cause damage. Reach down around the sides of the spark plug and gently pull on the end fitting of the wire that sits over the top of the spark plug.
  • If the cap and ignition wire don’t want to come off, rotate the rubber fitting one way or the other as you pull.

Removing Spark Plug WireSteve Maxwell for Family Handyman

Step 2

Test with a spark plug tester

  • Attach a spark plug tester to the ignition wire. At the other end, the tester connects to the spark plug as it sits in your engine.
  • Turn the ignition ON.
  • Start the engine, or simply turn it over if it won’t start, and watch the transparent sides of the tester. If no visible spark or glow is present, then you can be sure that no spark is occurring at the all-important tip of the spark plug. Does this mean the plug is bad? Not necessarily. The spark plug could be bad, yes, but lack of spark can also be caused by a fault somewhere else in the ignition system.

Spark Plug Tester GlowingSteve Maxwell for Family Handyman