Kitchen Cabinet Storage Solutions: DIY Pot and Pan Pullout
A solution to stooping, searching and stacking.
A few hours
IntroductionThe only time our pots and pans were truly organized was when they were new in the box—since then, it’s been “every pan for itself.” Pots and pans are difficult to organize; if you stack them up, it’s a hassle getting to the bottom ones. If you spread them out, they take up tons of valuable cabinet space. This pot and pan pullout makes your pans easy to access and organize and—depending on your cookware—may even give you a place to stash your lids. It only takes a couple of hours, a couple of boards and a couple of drawer slides. Note: This accessory is designed to support everyday pots and pans, not extremely heavy objects or kids doing pull-ups.
- Basic hand tools
- Router (optional)
- 1x4 x 4’ pine
- 20” heavy-duty/full-extension side-mount drawer slides (2)
- 3/4” x 3/4” x 3’ pine
- Clothesline or other hooks
How to build it
Empty your cabinet and measure the depth of the cabinet. Build the H-shape frame. The frame needs to be the same length as the inside depth of the cabinet, in our case 23 in. We cut our 1×4 support slat 21-1/2 in. long (two 3/4-in.-thick arms plus the 21-1/2-in. slat equals 23 in.). Predrill screw holes in the cross arms and bore countersink holes to accommodate the heads.
Screw on the two slides. Cut the carrier the same length as the depth of your cabinet. Flip the assembly over and attach the carrier. Install the hooks; we used beefy “clothesline hooks.” You may want to use shorter or skinnier hooks and space them differently, depending on the sizes of your pans.
Attach the H-frame in the center of the cabinet opening. Load up your pots and pans; you may want to readjust the spacing of your hooks based on how the pans fit. Then get cooking.
Project step-by-step (6)
Measure the cabinet
Measure the depth of the cabinet from the back to the inside of the face frame. This measurement determines the overall length of the H-frame.
Build the H-Frame
Screw the cross arms to the support slat. Predrill holes and countersink screw heads to prevent splitting.
Mount the drawer slides
Screw the slides into place with the back ends even with the back of the H–frame.
Screw the slides to the carrier
Cut the carrier to length, round the end and bore a finger hole, and then soften the edges with sandpaper or a router. Align the carrier with the back end of the slides.
Add the hooks
Secure the hooks to the carrier. Fiddle around with your pots and pans beforehand to determine the most efficient spacing.
Position the bottom of the cross arm even with the top of the cabinet opening and attach it with screws. Then secure the back end at the same elevation, using temporary braces to prop it up.
Every product is independently selected by our editors. If you buy something through our links, we may earn an affiliate commission.