How to Repair a Lawn Mower Pull Cord

Replace a broken starter rope in a half hour.

Every editorial product is independently selected, though we may be compensated or receive an affiliate commission if you buy something through our links. Ratings and prices are accurate and items are in stock as of time of publication.

Next Project


Replace a broken starter rope on your lawnmower quickly and easily by following this simple step-by-step procedure.

Tools Required

  • 4-in-1 screwdriver
  • Leather gloves
  • Needle-nose pliers
  • Nut driver

Materials Required

  • New pull rope

You tug one last time to get the lawnmower started, and suddenly the rope breaks and the end goes spinning into the hole. Don’t blow a gasket. If you have even a tinge of mechanical aptitude, replacing a starter rope is pretty easy. If the spring breaks—a rare event, according to our repair expert—the fix is a lot harder, and we recommend you take the mower to a repair center.

Check out what to do if your lawn mower won’t start.

Project step-by-step (4)

Step 1

Remove the Old Starter Rope

The first step in repairing a pull cord is to remove the rewind assembly from the lawnmower. How you do this will vary depending on your lawnmower model, but it’s usually held on by three or more screws.

Some mowers have a shroud covering the top of the mower. On these, you’ll have to search for and remove the screws that hold the shroud in place. If your rewind unit is held on by rivets instead of screws, see “No Screws?” below.

  • After you remove the rewind unit, flip it over and look inside to find the knotted end of the broken rope.
  • Grab it with a pair of needle-nose pliers and pull it out. You’ll thread the new replacement starter rope through this hole.

RemoveFamily Handyman

Step 2

No Screws?

Sometimes, rivets hold the rewind unit to the metal shroud. To access this kind of rewind unit, remove the bolts that hold the shroud to the engine. If the rivets are loose, drill them out and replace them with bolts and locknuts.

Tips to Winterize Your Lawn Mower

ScrewsFamily Handyman

Step 3

Install a New Rope

Before you install the new rope, you have to rewind the spring by twisting the rope pulley in the same direction it goes when you pull on the rope. You’ll know when you’re turning the pulley in the right direction because it will get harder to turn.

  • Keep turning the pulley until you feel resistance and it won’t turn easily.
  • Then let it unwind about one-half to one revolution until the hole in the pulley lines up with the hole in the rewind housing.
  • Wedge a screwdriver against the pulley to keep the spring from unwinding while you thread the rope through the holes.
    • Pro Tip: With leather gloves on, melt the end of the rope with a match. While the plastic is hot, give it a quick twist to create a pointed end so it’s easier to thread in.
  • Push the end of the rope through both holes and tie a knot.
  • Heat the knot a little bit with a match and pull it tight to keep it from coming undone.
  • Remove the screwdriver while you keep pressure on the pulley with your finger, and gradually let the rope wind onto the wheel.
  • You may have some extra rope to cut off after everything’s back together. Mount the rewind unit and reinstall any shrouding or other parts you had to remove.

ReplaceFamily Handyman

Step 4

Tie a Knot

  • Put the handle on the rope and tie a knot. Position the knot so that there’s a little tension on the rope when you release the handle.
  • If the rope on your lawn mower extends up the handle, make sure to place the rope handle in its final position before tensioning the rope slightly and tying the knot.
  • Let the pulley wind the rope back into the rewind.
  • Reinstall the rewind unit and any other parts you’ve removed.

knotFamily Handyman