Removing a Trailer Hitch BallUpdated: Jun. 30, 2017
Remove a rusted trailer hitch with penetrating fluid and air power
You might also like: TBD
Remove a rusted ball mount
Photo 1: Spray the rusted joint
Generously spray the opening to the hitch receiver with a penetrating fluid. Then insert the spray straw deep into the corners of the receiver and spray liberally.
Photo 2: Rap with an air hammer
Rap the sides, top and bottom of the hitch receiver for 15 seconds with blows from the air hammer. Spray again. Repeat the rapping until the ball mount loosens.
When the ball mount on your trailer hitch is rusted in place, don’t whack at it with a sledgehammer. Here’s what to do instead. Buy a can of CRC Freeze Off penetrating spray and an air chisel fitted with a “hammer bit.” The air chisel will run about $15 and the extra bit will be about $8. Spray the opening to the hitch receiver. This newest style of penetrating fluid chills the metal, causing it to contract to help break the rust seal. Then use an air chisel fitted with a hammer bit to knock everything loose. The air hammer will break up the rust, spread the penetrant and free up the ball mount. Once it’s free, just tap the rusted ball mount out with a hammer. If you plan to reuse the rusty mount, coat it with a rust converter or waterproof marine grease.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Air compressor
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Penetrating spray